메뉴 건너뛰기

::: welcome to ionestudio :::

XEDITION

Gallery



gold watchesMaking use of an open spool and whatever filament is cheapest on ebay can cause problems because the filament is low priced or the slicer is not precisely configured, as well as the cartridge avoids those. Unfortunately, it replaces all of them with flaky software. Prints neglect to start because the XYZWare pc software on the Mac claims there is a cartridge mistake, even though the printer doesn't see difficulty. Likewise, the printer will occasionally not print because it views an issue - that doesn't actually occur - aided by the cartridge.

While pulling the cartridge out and reseating it, possibly energy biking the printer along the way, generally fixes these, these are typically frustrating. Specially when the spoil a print by arriving in the center of the print! In specific, I had one print that failed 3 x because of such issues. Add in one failed printing considering that the bed required calibration plus one because I screwed up (forgot to place glue regarding the bed), and that took long sufficient I set the printing apart a short while later rather than using it as planned.

Do these folks even HAVE quality control? This filament wouldn't also give. I'd to pull quite difficult to get any to come out (and indeed I removed the plug first), I popped open the actual situation to see if i really could determine what was jamming it and found which they'd wound the filament therefore tight that the spool bulged away and was massaging in the situation. I tried unwinding some and winding it looser and that did actually work on first, but it jammed once more as well as the filament clicked during an extended over night print.

The printer (which can be likely to sense if the filament is lacking) kept 3d printing material without filament therefore given that cartridge thinks this has 30 meter less filament than it can and it STILL does not work properly right. The product is OK but i would suggest getting a cartridge reset device off Ebay and cut costs. I take advantage of Food safe 3d printing materials Hatchbox filament today materials for 3d printing $24 dollars a roll and you will get 2.2 pounds versus this which gold watches can be simply over a pound.

In the event that you have the reset device be sure to block XYZWare.exe from all online connections incoming and outbound or it will probably tell you straight to industrial 3D Printers only make use list of 3d print materials genuine XYZ filament which really is a rip off. Nevertheless the printer I favor!! utilize bed temp 90C and extruder temp 250C and your print quality will undoubtedly be amazing.
TAG •

위로